9200 doesn't always record « My Humax Forum

My Humax Forum » Freeview SD » PVR 9150T, 9200T, 9300T

9200 doesn't always record

(7 posts)

Rbrum

new member
Joined: Oct '13
Posts: 4
offline

Instant record always works but timed recording do not always. The show is shown in the schedule but not in recorded programmes.

I have formatted the hard disk - twice - and also reset settings to factory settings. And switched off at the mains & on again.

Any ideas?

| Tue 22 Oct 2013 21:16:56 #1 |
Rbrum

new member
Joined: Oct '13
Posts: 4
offline

Hardware PVR9200T
Software version PGXTF 1.00.23 - which I think is the most recent?

| Tue 22 Oct 2013 21:22:04 #2 |
Biggles

special member
Joined: Apr '11
Posts: 613
offline

Do you have channels numbered from 800? If so try this.

| Tue 22 Oct 2013 23:54:22 #3 |
Rbrum

new member
Joined: Oct '13
Posts: 4
offline

I'll give this a try - many thanks.

| Wed 23 Oct 2013 16:01:38 #4 |
Rbrum

new member
Joined: Oct '13
Posts: 4
offline

I did this, used the numbers for my region & no longer have any channels over 800. However, it still doesn't always record.

Only question - when I did the manual search I had to choose whether to enable or disable the network search. I chose to disable - was that correct?

I'm wondering if it only records when left on rather than standby.

| Sat 26 Oct 2013 15:03:36 #5 |
Martin Liddle

special member
Joined: Feb '11
Posts: 4,617
offline

Rbrum - 43 minutes ago »
I'm wondering if it only records when left on rather than standby.

When the Humax is in standby does it display the time on the front panel display or --:-- ?

| Sat 26 Oct 2013 15:47:40 #6 |
Biggles

special member
Joined: Apr '11
Posts: 613
offline

Rbrum - 3 hours ago »
I did this, used the numbers for my region & no longer have any channels over 800. However, it still doesn't always record.
Only question - when I did the manual search I had to choose whether to enable or disable the network search. I chose to disable - was that correct?
I'm wondering if it only records when left on rather than standby.

Yes that is correct. Network Search is disabled by default and should stay that way, that's why I don't mention it in my instructions. And your last sentence is a tell-tale clue, hence Martin's question.

| Sat 26 Oct 2013 19:04:01 #7 |