9150T Application Loader Problems

My Humax Forum » Freeview SD » PVR 9150T, 9200T, 9300T

9150T Application Loader Problems

(6 posts)

welldigger99

new member
Joined: Sep '12
Posts: 3
offline

Hi,
I have a Humax 9150T PVR which has given good service until developing a fault recently. On start up the unit just keeps on repeatedly launching the Application Loader software (running a4.39) When it reaches 100% a small "click" is heard from inside the unit before repeating the same routine over and over. Any ideas please?

| Tue 25 Sep 2012 20:33:19 #1 |
Barry

senior admin
Joined: Feb '11
Posts: 11,052
offline

Welcome to the Forum

Similar problem recently reported with a 9300 see this thread see if it helps:

http://myhumax.org/forum/topic/9300t-not-switching-on

| Tue 25 Sep 2012 20:41:11 #2 |
welldigger99

new member
Joined: Sep '12
Posts: 3
offline

Thanks for the reply Barry. Unfortunately, I cannot get as far as bringing up the menu screen. After the loader bar has reached 100% the screen goes blank and starts the cycle again. I notice also that the standby light is green throughout and will not respond to the remote. The fan also stops and starts, during the routine I have described. Thinking of perhaps a power supply problem?

| Wed 26 Sep 2012 21:11:39 #3 |
Biggles

special member
Joined: Apr '11
Posts: 619
offline

Are you saying you can't get into the menu even with the aerial removed?

| Thu 27 Sep 2012 9:10:44 #4 |
Martin Liddle

special member
Joined: Feb '11
Posts: 4,711
offline

welldigger99 - 12 hours ago »
After the loader bar has reached 100% the screen goes blank and starts the cycle again.

This problem has been reported a few times previously and I don't think we have ever found a satisfactory solution; hope I can be proved wrong.

| Thu 27 Sep 2012 9:33:06 #5 |
welldigger99

new member
Joined: Sep '12
Posts: 3
offline

Yes, Biggles that is correct. There is no interaction with the remote at all -aerial in or out.

| Thu 27 Sep 2012 20:40:28 #6 |