2000Tset up problem « My Humax Forum

2000Tset up problem

(4 posts)

Ambrose1

new member
Joined: Aug '14
Posts: 2
offline

I bought this Humax on the weekend. The set-up programme stalled at the first page about language. I selected English and pressed OK. There was no reaction and it stuck on that page. Eventually, I turned it off to start again. It does not restart the set up procedure. How do I get back to beginning? The control turns the Humax on and off but does nothing else works. The TV is routed through the Humax and for the time being I am using the TV control for channel selection, but recording is not possible

I will take it back for an exchange but would like to know, in case it happens again.

| Sun 3 Aug 2014 21:17:30 #1 |
Barry

senior admin
Joined: Feb '11
Posts: 11,040
offline

Welcome to our Forum

How was the unit connected to tv?

If HDMI then try using a scart cable and see if the set up process is displayed again and continues. After language the next item in the set up process is display.

| Mon 4 Aug 2014 9:15:55 #2 |
Ambrose1

new member
Joined: Aug '14
Posts: 2
offline

Thank you Barry, I did try the Scart cable as an alternative to the HDMI cable. It made no difference.The 2000T manual shows the sequence of screens that should follow.
regards, Ambrose

| Mon 4 Aug 2014 10:11:29 #3 |
Barry

senior admin
Joined: Feb '11
Posts: 11,040
offline

Sounds like it is faulty then, back to retail for exchange.

| Mon 4 Aug 2014 10:17:39 #4 |