After disconnecting both satellite cables during a storm, I have re-connected them, but now my Foxsat is only detecting 1 cable. I have checked the connectors, and tried a factory reset but without success. Cab anyone please help...
My Humax Forum » Freesat HD » FOXSAT HDR
Foxsat HDR not detecting 2 cables
(8 posts)-
| Fri 8 May 2020 10:11:02 #1 |
-
Try swapping the two input cables.
| Fri 8 May 2020 10:24:19 #2 | -
Thanks Graham - I tried that and did a reset a couple of times but no cables were detected. I then re-swapped them, and I am back to square 1, only 1 cable is detected. I might add, that although the cables were disconnected due to a forecast storm, it never arrived, so it cannot be damage from lightning!
| Fri 8 May 2020 17:09:36 #3 | -
ragoo44 - 3 hours ago »
Thanks Graham - I tried that and did a reset a couple of times but no cables were detected. I then re-swapped them, and I am back to square 1, only 1 cable is detected. I might add, that although the cables were disconnected due to a forecast storm, it never arrived, so it cannot be damage from lightning!Is the dish accesible ?
Can you swap the lnb easily.
| Fri 8 May 2020 20:25:21 #4 | -
No, that's a bit tricky - do you think it is a faulty lnb?
| Sat 9 May 2020 9:44:51 #5 | -
You did say you had checked the connectors, I would also take a second look and make sure no braid is touching the internal core on the non functioning cable.
In any case it is always a good idea to keep a spare LNB as they can go quite quickly - one I fitted went in 2 months and It was a well know brand with an excellent reputation.| Sat 9 May 2020 12:00:42 #7 | -
OK, thanks. Will check and maybe get new connectors. Will let you know. Best regards
| Sat 9 May 2020 13:09:49 #8 |
Reply
You must log in to post.
