My Humax Forum » Freeview HD » FVP 4000T, 5000T

FVP-4000T not reponding to working Remote Contol

(3 posts)
  1. User has not uploaded an avatar

    jagman1

    new member
    Joined: Sep '17
    Posts: 4

    offline

    Hello,
    Humax FVP-4000T.
    The original RM-L08 remote does not work and a replacement works with my FVP-5000T but not the FVP4000T.
    I have tried to syn the replacement remote using the instructions given by Humax, i.e. pressing and holding the “OK “ and 0 buttons for 8 to 10 seconds but I get no response at all, however this replacement works fine with the FVP-5000T. This seems to point to the problem being with the main Humax Unit.

    I can open the main unit, but is there anything I can do to get it working?

    Hoping you can help.

    Thanks.

    | Mon 31 Mar 2025 11:03:38 #1 |
  2. User has not uploaded an avatar

    trog

    special member
    Joined: Dec '12
    Posts: 276

    offline

    https://myhumax.org/forum/topic/need-to-reset-remote-control-for-fvp-4000t

    | Mon 31 Mar 2025 11:33:12 #2 |
  3. User has not uploaded an avatar

    EEPhil

    special member
    Joined: Oct '14
    Posts: 380

    offline

    It sounds like you may have changed, and forgotten, the remote code on the 4000T.

    Is the replacement remote an official Humax replacement or something either generic or from another manufacturer?

    If it isn't Humax you won't be able to change the code.

    If it is a Humax remote follow the instructions at https://myhumax.org/forum/topic/multi-code-function-hdhdr-remote-2. As you can't get the 4000T to respond press 0 and OK for the 8-10 seconds and assume the remote has gone into the setup mode. Then press 2 and then try channel up/down and see if the 4000T responds. If it doesn't repeat the whole process with 3 or 4 or 5 or 6 until it works.

    If it never works you could try setting 1 which I assumed was the default setting.

    If all else fails, or the new remote isn't
    a genuine Humax, and the new remote will operate the 5000T swap the remotes and see if the old remote will work the 4000T. If necessary repeat the above process on the old remote/4000T combination.

    | Mon 31 Mar 2025 16:21:57 #3 |

RSS feed for this topic

Reply

You must log in to post.