Today my iCord stopped reacting to remote or button commands. iCord Time is strangely showing 14:00 15-Oct-2005. Program is still shown but is kept on one channel. Hard Disk is audible, so assume it is running. Hard switch on/off does not reset the problem. Anyone of you experienced before? Any solution known in this forum?
My Humax Forum » Miscellaneous » Other Humax Products
iCord does not respond to remote or button command
(2 posts)-
| Sat 9 Jul 2022 21:21:19 #1 |
-
Yes, the same for mine.
The channel tuned blocked PVR.
Please:
1) turn off and disconnect PVR by electrical network;
2) disconnect by satellite;
3) turn on the PVR;
4) remove the last channel by PVR memory;
5) connect with satellite's antenna;
6) PVR run ok.
Bye| Sun 14 Aug 2022 13:23:52 #2 |
Reply
You must log in to post.
