My Humax Forum » Freesat HD » FOXSAT HD

Lost channels

(5 posts)
  1. User has not uploaded an avatar

    Overlander

    new member
    Joined: Apr '19
    Posts: 2

    offline

    Hi, Just had the dish replaced & now these news channels 205. 206. . 208. . 209 . 210. . Are showing “. No signal “. . Had the installer back & he cannot find a fault . Any suggestions? What do these channels have in common that are different to other channels ? Thanks in advance .

    | Thu 4 Apr 2019 13:15:03 #1 |
  2. grahamlthompson

    grahamlthompson

    special member
    Joined: Feb '11
    Posts: 14,442

    offline

    Welcome to our forum.

    I can't see why 205 should be an issue because according to Kingofsat (might be a mistake, it's on a high field strength UK spot beam transponder.

    The others are on wide beam Pan Europe transponders so are much weaker than the UK spot beam transponders.

    205 FRANCE 24(ENG) 11426 V UK ?????
    206 RT HD 11225 V EUROPE
    207 CNN 11670 H EUROPE
    208 Bloomberg TV 11685 V EUROPE
    209 NHKWORLD-JAPAN 11225 V EUROPE
    210 CNBC 11479 V EUROPE

    Suggests the dish alignment needs looking at. On my box all the Europe beam transponders show around 60% signal strength but more significantly 100% quality.

    All the UK spot beams have 100% quality and signal.

    What does the box say the strength and quality is when viewing the BBC ITV and Channel 5 HD channels.

    | Thu 4 Apr 2019 13:48:05 #2 |
  3. User has not uploaded an avatar

    Overlander

    new member
    Joined: Apr '19
    Posts: 2

    offline

    Thanks for the quick reply . Signal strength was 80% & 100 quality .
    My 1st though was the dish needs tweeking , but the Fitter says the dish is alignment is correct . I have a second Humax box set up in another room & have exactly the same problems there , so it's not the box .

    | Fri 5 Apr 2019 14:51:21 #3 |
  4. grahamlthompson

    grahamlthompson

    special member
    Joined: Feb '11
    Posts: 14,442

    offline

    Overlander - 7 minutes ago  » 
    Thanks for the quick reply . Signal strength was 80% & 100 quality .
    My 1st though was the dish needs tweeking , but the Fitter says the dish is alignment is correct . I have a second Humax box set up in another room & have exactly the same problems there , so it's not the box .

    You should easily get 100% for strength on any of the UK spot beam transponders even using a zone 1 Sky Minidish unless you are really a long way north .

    https://www.satbeams.com/footprints?beam=7491

    I can get 100/100 using a tiny portable camping dish in the Midlands

    | Fri 5 Apr 2019 15:03:17 #4 |
  5. REPASSAC

    REPASSAC

    special member
    Joined: Mar '11
    Posts: 4,100

    offline

    If the dish and units are OK, then that leaves the cabling or RF interference.

    Check the problem channels here.
    If they are close together then it is either water ingression or RF interference, the former is my bet as two units have the same problem.

    It would have been good to have the fitter check the signal at both ends of the cable.

    | Fri 5 Apr 2019 15:11:54 #5 |

RSS feed for this topic

Reply

You must log in to post.