My Humax Forum » Miscellaneous » The Lounge

Override the standby mode on Manhattan T3-R

(3 posts)
  1. User has not uploaded an avatar

    Chorlton

    member
    Joined: Oct '20
    Posts: 11

    offline

    I have recently purchased the Manhattan T3-R Freeview PVR (actually only yesterday) and this morning I noticed overnight the PVR had gone into standby mode.

    Some people may know I use my PVR to send an aerial signal to my portable televisions. Therefore in order to watch TV on the portables I need to go downstairs and turn my Manhattan PVR on first. Is there a way to override my PVR going into standby mode? It's not the end of the world if there isn't I was just wondering.

    Thank you for any help.

    | Wed 21 Oct 2020 8:44:46 #1 |
  2. Admin

    Admin

    administrator
    Joined: Feb '11
    Posts: 129

    offline

    https://manhattan-tv.com/assets/pdf/guides/Manhattan_T3-R_Get_Started_v3.1.pdf

    Bottom page 18 details how to 'Loop out in standby'

    | Wed 21 Oct 2020 9:09:49 #2 |
  3. grahamlthompson

    grahamlthompson

    special member
    Joined: Feb '11
    Posts: 14,442

    offline

    Not familiar with the Manhattan User Interface

    However on Humax boxes you can set a power on power off timer pair.

    Other than that a remote infra red transmitter pair should let you use the manhattan remote upstairs.

    https://www.amazon.co.uk/LINDY-100-Wireless-IR-Extender-Black/dp/B01C3ODR14

    | Wed 21 Oct 2020 9:14:57 #3 |

RSS feed for this topic

Reply

You must log in to post.