My Humax Forum » Freeview HD » FVP 4000T, 5000T

Recordings won't Play back.

(5 posts)
  1. User has not uploaded an avatar

    Transwest

    junior member
    Joined: Jan '16
    Posts: 7

    offline

    Hi Guys

    I’ve been trying to watch some of my recordings, done recently, on my new FVP 4000T.

    I’ve recorded and watched quite a few, but 2 of them (currently) wont ‘play’.

    When I go to All Video’s, & click on the program/s, it goes as far as the screen with ‘left’ ‘right’, ‘pause’ buttons etc, but then nothing.

    The programs do appear in the listings.

    I’ve tried pausing, un-pausing, left, right, stop, start etc, to no avail.

    Also, when I click Back at this point, it goes to a blank screen. I have to press Back [i]again, to get back to the listings.

    Any ideas please ?

    Thanks for reading this.

    | Sat 16 Jan 2016 6:09:52 #1 |
  2. Barry

    Barry

    senior admin
    Joined: Feb '11
    Posts: 11,052

    offline

    Never witnessed similar, but having to press back twice would appear to indicate it is in playback mode.

    What channel/programme?

    Have you tried a power cycle of the unit, failing that I would contact Humax support.

    | Sat 16 Jan 2016 9:11:02 #2 |
  3. User has not uploaded an avatar

    Transwest

    junior member
    Joined: Jan '16
    Posts: 7

    offline

    Hi again Barry,

    The channels were Channel4 & BBC2 on Friday night.
    Yep - it should be in playback mode, although when it is in PB and I click Back, it only takes one click to go back to the listings.

    BBC2: Mastermind: 20:01 - 20:30
    Channel 4: 8/10 Cats 21:01 - 22:03,
    so they aren't even over-lapping.

    Programs before - and after that - were fine.

    How do I do a power cycle ?

    (Thanks for the info on other question as well)

    | Sat 16 Jan 2016 9:35:37 #3 |
  4. Barry

    Barry

    senior admin
    Joined: Feb '11
    Posts: 11,052

    offline

    Switch to standby, wait for 2 minutes then disconnect/reconnect power.

    | Sat 16 Jan 2016 9:42:33 #4 |
  5. User has not uploaded an avatar

    Faust

    special member
    Joined: Jun '13
    Posts: 1,598

    offline

    transwest - 8 hours ago  » 
    Hi Guys
    I’ve been trying to watch some of my recordings, done recently, on my new FVP 4000T.
    I’ve recorded and watched quite a few, but 2 of them (currently) wont ‘play’.
    When I go to All Video’s, & click on the program/s, it goes as far as the screen with ‘left’ ‘right’, ‘pause’ buttons etc, but then nothing.
    The programs do appear in the listings.
    I’ve tried pausing, un-pausing, left, right, stop, start etc, to no avail.
    Also, when I click Back at this point, it goes to a blank screen. I have to press Back [i]again    , to get back to the listings.
    Any ideas please ?
    Thanks for reading this.

    How many minutes does it say has been recorded? I've seen recordings where everything appears okay but when I check minutes it states 0 minutes hence it hasn't actually recorded.

    | Sat 16 Jan 2016 14:26:32 #5 |

RSS feed for this topic

Reply

You must log in to post.