I have had a further two since my last post. I have noticed on the last two that after the reboot none of the wireless network stuff is working. I can't even scan for available devices to connect to. I have to shutdown and remove power, before it can connect to anything again. This might be a lead as to what is crashing the box. I don't have a wired connection so I don't know if it is just the wireless network stuff or all of it. This has only started to happen since the new update too.
My Humax Forum » Freeview HD » FVP 4000T, 5000T
Software update
(102 posts)-
| Fri 26 Aug 2016 11:07:49 #51 |
-
Mine has always been connected by Ethernet,and still happened on the one occasion since the software update.
| Fri 26 Aug 2016 11:12:11 #52 | -
I that case my observation might be more misleading than help.
| Fri 26 Aug 2016 15:07:05 #53 | -
What on earth have Humax done to my box with the new software update! Just rebooted again whilst watching a recording. This never happened before the update.
| Fri 26 Aug 2016 17:55:22 #54 | -
Mine
s just rebooted for the 2nd time since the latest update. Never happened before in the 8 months ive had it & rather annoying if recording at the time. As said loses the internet connection as well.| Fri 26 Aug 2016 17:57:07 #55 | -
As it's not something I'm likely to use, I turned remote recording off - no more reboots since!
| Fri 26 Aug 2016 19:00:11 #56 | -
And I've had the box running all day as I've been catching up on recordings and watching the F1 practices
| Fri 26 Aug 2016 19:00:57 #57 | -
Remote recording is turned off on mine,but still two reboots,one which wrecked an active record. Humax have turned my once ultra reliable box,into the complete opposite. I just hope they are aware of the problems they have created,and put it right with an urgent update.
| Fri 26 Aug 2016 19:06:34 #58 | -
Just checked & my remote recording was set to off by default & it`s crashed twice since the update.
| Fri 26 Aug 2016 19:19:10 #59 | -
Barry,are Humax aware what a disaster the latest update is?
| Sat 27 Aug 2016 4:28:55 #60 |
Reply »
You must log in to post.
