My Humax Forum » Freeview HD » YouView DTR-T

Switch off TV with YouView remote

(6 posts)
  1. User has not uploaded an avatar

    Annex

    junior member
    Joined: Apr '17
    Posts: 8

    offline

    I have successfully programmed my YouView remote to control my Samsung TV.
    It works fine for volume, etc, but if I try to switch the TV off, only the YouView switches off - not the actual TV.
    YouView is on HDMI3. When I switch off, I just get 'No signal' rather than TV switching off. I have to use the Samsung remote to turn the TV off, which seems a bit silly.

    Can I fully program my YouView remote so that I don't need another one at all?

    | Mon 5 Jun 2017 14:03:45 #1 |
  2. REPASSAC

    REPASSAC

    special member
    Joined: Mar '11
    Posts: 4,100

    offline

    If multiple codes were listed for the TV try one of the others.

    | Mon 5 Jun 2017 14:34:44 #2 |
  3. Barry

    Barry

    senior admin
    Joined: Feb '11
    Posts: 11,052

    offline

    Are you pressing the TV button on the YouView remote before trying to switch TV off?

    | Mon 5 Jun 2017 14:42:42 #3 |
  4. User has not uploaded an avatar

    Annex

    junior member
    Joined: Apr '17
    Posts: 8

    offline

    REPASSAC - 57 minutes ago  » 
    If multiple codes were listed for the TV try one of the others.

    The code I used works perfectly well except for actually switching the set off. Would a different code make any difference, please?

    | Mon 5 Jun 2017 15:33:51 #4 |
  5. User has not uploaded an avatar

    Annex

    junior member
    Joined: Apr '17
    Posts: 8

    offline

    Barry - 51 minutes ago  » 
    Are you pressing the TV button on the YouView remote before trying to switch TV off?

    There is nothing labelled TV on the remote. I have tried pressing the on/off button at the top. I have even tried pressing AD button with the Off switch.

    I must be doing something wrong!

    | Mon 5 Jun 2017 15:37:57 #5 |
  6. User has not uploaded an avatar

    Annex

    junior member
    Joined: Apr '17
    Posts: 8

    offline

    Think I've managed it with a new code!
    Thanks for your replies.

    | Mon 5 Jun 2017 16:02:04 #6 |

RSS feed for this topic

Reply

You must log in to post.