My Humax Forum » Freeview HD » FVP 4000T, 5000T

2 Humax PVRs remote control interference issues

(2 posts)
  1. User has not uploaded an avatar

    svtdot

    junior member
    Joined: Jun '16
    Posts: 5

    offline

    I have just bought a new Humax FVP-4000T and spent this morning setting it up. I already have a Foxsat HDR that I want to use at the same time, but the remote controls are not independent.
    Contacted Humax telephone support and was advised to switch off one PVR completely and then press OK and 0 simultaneously on the relevant remote for the working machine. This advice is also echoed on your forum.
    I have now tried this at least 30 or 40 times with either one PVR in use or the other. The message is always the same: “Failed changing remote control code. Try again.”
    A second telephone call to Humax advised that this was a question of technique. I have tried doing it quickly and waiting for a variable number of seconds. The result is always the same.
    If it is a question of technique, can someone offer me some more advice

    | Tue 7 Jun 2016 15:33:24 #1 |
  2. Barry

    Barry

    senior admin
    Joined: Feb '11
    Posts: 11,040

    offline

    Welcome to our Forum

    When you press and hold the OK and 0 together do you see the change code message on screen:

    "You can change the remote control mode.
    Press a Numeric Key (<1> ~ <6>) to select the mode
    Current mode: Mode 1."

    If not, you will just have to keep trying, as support have stated it is just a matter of technique, frustrating as it is for you.

    | Tue 7 Jun 2016 16:08:43 #2 |

RSS feed for this topic

Reply

You must log in to post.