I think I know the answer, but I will ask it anyway in case I am wrong.
Is there any straightforward way to transfer recordings made on a 9300T onto a 5000T? I emphasise "straightforward" because complex solutions would probably be beyond me.
My Humax Forum » Freeview HD » FVP 4000T, 5000T
9300T to 5000T?
(4 posts)-
| Sun 24 Dec 2017 11:21:35 #1 |
-
The 9300T uses a propriety disk operating system. Software exists for the PC which is based on running a command window (DOS) utility though there is a post on this forum that indicates a GUI add on for windows exists that allows the files to be located and copied. You would need to remove the drive and connect it to a PC (easiest way is i slot in USB drive caddy. The recordings are in a transport stream container (.ts), once you have these on a PC you have the option of copying then to a 5000T or playing them back with the 5000T over a home network.
I never had a 9300T but I did have a 9200T, it was possible to copy files (rather slowly) to a PC using USB. My memory may be a bit dimmed as I had a Topfield 5800 at the same time one copied to a PC directly using USB and the other to USB mass storage device connected to the pvr.
Not sure if the usb export capability made it to the 9300T.
| Sun 24 Dec 2017 13:37:01 #2 | -
grahamlthompson - 38 minutes ago »
Not sure if the usb export capability made it to the 9300T.Unfortunately it didn't. It may have been in one of the pre-launch designs of the 9300T as the first models off the production line had a seal over where the USB slot would have gone. One of the early reviews had a photo of the back with a USB port showing but this was not the one released.
| Sun 24 Dec 2017 14:19:47 #3 | -
Thanks folks, I think you have confirmed my belief that it is not easily, if at all, possible. I am definitely not into taking the drive out of the 9300!
| Sun 24 Dec 2017 18:04:20 #4 |
Reply
You must log in to post.
