Foxsat HDR/500 has stopped taking remote control

My Humax Forum » WELCOME to the forums!

Foxsat HDR/500 has stopped taking remote control

(7 posts)

Michael55

junior member
Joined: Nov '16
Posts: 9
offline

... commands.
Good morning everyone.
This is my first post.
I collected the above from the Post Office yesterday (Ebay purchase), plugged it in, was surprised it worked perfectly with no need to even do a satellite Search.
I recorded something in the afternoon as a test - Perfect.
But later in the evening, it stopped taking commands from the remote, it is stuck on ITV1. I have rebooted, unplugged, turned off, bu no joy. Still stuck on ITV1. Can anyone help?
Thanks.

| Sun 27 Nov 2016 8:50:56 #1 |
Barry

senior admin
Joined: Feb '11
Posts: 11,052
offline

Welcome to our Forum

Have you tired new batteries in remote?

Does it respond to buttons on front of unit behind flap?

If all else fails you could try a remote recode see FAQ

| Sun 27 Nov 2016 10:19:30 #2 |
Michael55

junior member
Joined: Nov '16
Posts: 9
offline

Thanks Barry
Yes batteries are fine, remote flashes red when I press buttons.
I had looked at the remote recode option, but it scared me a bit #technophobe.
I'll try the buttons behind flap, it opened yesterday by accident when I took recorder out of the box, but coukdn't open it again last night
Cheers.

| Sun 27 Nov 2016 11:38:32 #3 |
dino

special member
Joined: Dec '11
Posts: 197
offline

Make sure it is the 'PVR' LED which flashes red when you press the buttons on the remote control. If not, press the PVR button itself, then try.

| Sun 27 Nov 2016 15:15:42 #4 |
Michael55

junior member
Joined: Nov '16
Posts: 9
offline

That was it Dino. Many thanks.
It was the 'TV' that was flashing when I pressed the buttons. I pressed 'PVR' ... all ok again :D.
I wonder how it got into that frozen' state last night. Must have been something I did without realising.

| Sun 27 Nov 2016 16:17:55 #5 |
dino

special member
Joined: Dec '11
Posts: 197
offline

You're welcome.

It is easily done. The remote control has four modes. It controls the Humax, but you can program it to control a TV, a DVD player and an Audio device.

If you use it as a multi-role controller, you switch it between modes using the 4 white buttons and it indicates what role it is in by lighting the appropriate white button when you press a normal button.

At some point you have pressed white 'TV' button - so it will have been sending signals for a TV. Pressing white 'PVR' switches it back to controlling the Humax.

| Mon 28 Nov 2016 19:30:50 #6 |
Michael55

junior member
Joined: Nov '16
Posts: 9
offline

Cheers.
I have downloaded the manual PDF now.

| Wed 30 Nov 2016 13:19:27 #7 |