I do live in Australia
My Humax Forum » Miscellaneous » Other Humax Products
My Humax won’t tape my shows
(15 posts)-
| Wed 14 Dec 2022 8:21:13 #11 |
-
If this a new Humax? Has it ever worked properly?
What sometimes works with UK models is to switch off at the plug. Leave for a while (some models have required longer than others - anything from power on immediately, 5 minutes or even 30 minutes have been suggested). Power on and see if this sorts out the problem. Or try Factory Default. Both of these are the standard response from the UK Humax help people. Sometimes the Humax gets confused and powering off completely resets things, so it does work - sometimes. If you reformat without powering off (not obvious that formatting was needed) then the underlying confusion won't be cleared. If you have already tried this then you could be looking at a hardware fault.
| Wed 14 Dec 2022 9:09:46 #12 | -
SSThing - 6 hours ago »
jdlfreetime - 18 mins ago »
prking - 1 hour ago »
That’s an Australian model, it’s unlikely to work in the UK.That would explain why. You need to use a UK PVR. Many good models available. John L
Has it occurred to you that Rochie might actually live in Australia?
Yes I read that bit. It should work ok in Australia unless there is a fault with Hard drive. John L
| Wed 14 Dec 2022 14:40:23 #13 | -
Thanks for advice, I switched off at PowerPoint and it is working again.
| Wed 14 Dec 2022 20:16:57 #14 |
Reply
You must log in to post.
