My Humax Forum » Freeview SD » PVR 9150T, 9200T, 9300T

pvr9150t dead?

(5 posts)
  1. User has not uploaded an avatar

    gnor20

    new member
    Joined: Dec '11
    Posts: 3

    offline

    My pvr 9150t showed an display of no signal when i turned it on and it would not turn to standby so i turned it off on the switch on the back. When i turned it back on the fan noise was really loud and only one green light came on the front display by the standby light.
    nothing was displayed on the screen.
    I believe i have the current correct software uploaded (up loaded in Dec 2011).
    I have turned it off and unplugged the aerial and turned on again but only the same green light come on and no display on screen.
    I have down as above and turned on with standby button pressed in but same problem.
    any ideas of what to try or is it dead?
    thanks

    | Fri 18 May 2012 19:27:40 #1 |
  2. User has not uploaded an avatar

    Martin Liddle

    special member
    Joined: Feb '11
    Posts: 4,711

    offline

    gnor20 - 2 hours ago  » 
    any ideas of what to try or is it dead?

    I don't immediately recognise the symptoms. If the box is out of warranty, I would try opening the box and disconnecting the connections to the hard drive. If it will now boot then formatting the disk in a PC will probably resolve the problem.

    | Fri 18 May 2012 22:22:53 #2 |
  3. User has not uploaded an avatar

    dannyboy51

    new member
    Joined: Aug '12
    Posts: 1

    offline

    Hi, I have a similar problem.

    Turned my PVR9150T box on the other day. The fan makes a noise, the screen stays black and then for a fraction of a second something saying 'BBC 1 - No Signal' pops up and then the box turns restarts automatically and repeats the same process, over and over again. None of the buttons on the box or remote work, so I can't even get into the menu to do a factory reset. Any ideas? Did you end up fixing your box Gnor?

    Regards, Dan.

    | Sat 18 Aug 2012 2:13:01 #3 |
  4. User has not uploaded an avatar

    Martin Liddle

    special member
    Joined: Feb '11
    Posts: 4,711

    offline

    dannyboy51 - 6 hours ago  » 
    None of the buttons on the box or remote work, so I can't even get into the menu to do a factory reset.

    Try turning the Humax off, disconnect the aerial and then start it up without the aerial. Does this allow you to do a reset to default settings?

    | Sat 18 Aug 2012 8:15:32 #4 |
  5. Barry

    Barry

    senior admin
    Joined: Feb '11
    Posts: 11,052

    offline

    Link to FAQ:

    http://myhumax.org/forum/topic/remote-control-has-stopped-working-unit-failing-to-respond

    | Sat 18 Aug 2012 8:50:47 #5 |

RSS feed for this topic

Reply

You must log in to post.