Setup problem « My Humax Forum

Setup problem

(6 posts)

deggitt

junior member
Joined: Mar '13
Posts: 6
offline

I originally set up my recorder on a single satellite input. I now wish to add a second to enable simultaneous recording and viewing, but cannot get back to a setup screen to do so. Any suggestions?

| Sun 10 Mar 2013 21:10:35 #1 |
-gonzo-

special member
Joined: Feb '13
Posts: 660
offline

Factory reset will start the installation wizard again.

| Sun 10 Mar 2013 21:42:59 #2 |
deggitt

junior member
Joined: Mar '13
Posts: 6
offline

Thanks gonzo, however, I can't find from any of the accompanying paperwork, how to do a factory reset! Can you explain the process please?

| Mon 11 Mar 2013 9:24:29 #3 |
Barry

senior admin
Joined: Feb '11
Posts: 11,052
offline

I'll welcome you to the Forum

and jump in here:

Settings
System Settings
Factory default

Default password is 0000 (4 zero's if required)

Make a note of your timers as they will be reset as well, recordings will be unaffected.

| Mon 11 Mar 2013 9:27:39 #4 |
deggitt

junior member
Joined: Mar '13
Posts: 6
offline

Thanks Barry. I have no idea how I did not find the factory setup on the menus, I was convinced I had run through all of them! The whole thing now works fine.

| Thu 14 Mar 2013 12:03:16 #5 |
REPASSAC

special member
Joined: Mar '11
Posts: 4,100
offline

I don't think you can see it when recording. I liked the Foxsat method of showing them greyed out.

| Thu 14 Mar 2013 12:29:15 #6 |

You must log in to post.