The 1100s I have had for just under 2 years with hardly a problem (watch that change now I've "said" it out loud) and I'm very pleased with it. I have a Panasonic Viera TV which has also, so far given good service. In the past 3 months or so, sometimes (just when you think it's gone away it comes back) when switching on the Humax, the TV will come on as it normally does when the Humax gives out a signal, and then before the Humax completes its boot process, the TV mains light turns to flashing green (on) led then goes off. It's a simple matter to correct with the non-remote controls on the back of the TV. Switch off then switch on and all is well.The Humax has completed its boot process by this time.
Where do I start looking? TV or Humax and in what areas? I recollect settings on the TV to switch on if a signal is detected but all I can do is switch it off.Just looking for TS tips at this point. TIA.
My Humax Forum » Freesat HD » HDR 1000, 1010, 1100S
TV loses Connection with 1100s at power up
(1 post)-
| Wed 28 Feb 2018 12:06:06 #1 |
Reply
You must log in to post.
