boogersa - 1 mnth ago »
I am getting the occasional picture breakup/pixelation but only for a second or two. It’s more flaky than the 5000t I have. Aura sIgnal strength is in the high 80% and quality is between 95-100%, sometimes reaching 100% I don’t know if this can be fixed by firmware updates. If it starts to annoy me it’s going back.
Certain channnels don’t display for me due to weak signal. The aerial works fine on my tv so there must be a box issue
I had a lot of breakup on the main PSB hd channels on my new box, and signal strength and quality was poor. Turns out I was picking them up from a relay and not the main transmitter, doing a manual scan on the correct channel for the main transmitter (and changing type to dvb-t2) resolved the issue for me.
I’ve fitted an attenuator but lowest signal strength I can get is 90% might need to purchase a better one
Mason Storm - 2 hours ago »
I’ve fitted an attenuator but lowest signal strength I can get is 90% might need to purchase a better one
Has it made any difference? Whilst I would normally advise going a bit lower than 90% (typically 80% - 85%) I would have expected you would see an improvement if signal strength is the problem.
You must log in to post.
