North is at the top
My Humax Forum » Freeview HD » Aura UHD
Aura Signal Strength?
(105 posts)-
| Thu 10 Dec 2020 18:12:29 #91 |
-
| Thu 10 Dec 2020 18:28:27 #92 |
-
Something went wrong
| Thu 10 Dec 2020 18:30:34 #93 | -
| Thu 10 Dec 2020 18:31:32 #94 |
-
stevehasahumax - 9 hours ago »
Martin hi good morning, well the results are in - I had to wait for daylight .. the current aerial was put up 10 years ago and it is 100 percent guaranteed that it does indeed POINT towards a transmitter called
SANDY HEATH
Does this mean I now need to start again on the manual tune with a different set of Ch Numbers? etcDo you have Google earth on your PC ?
Most houses nearby are pointing to sandy Heath direction.| Thu 10 Dec 2020 18:47:26 #95 | -
hi all, I don't have google earth sorry. I did some asking on the local WhatsApp about tv connections. There seems to be some stories about tv aerial changes being done because of the demise of analogue Tv sets, also because the local transmitter was going to cease to operate , and also again it was down for 6 months or operating on low power so no one could watch anything.. one thing for sure.. something prompted a "mass" aerial activity , most of which resulted in re-positioning - rightly or wrongly.
my own experience continues to be poor coverage and lost channels and broken pixelated picture quality... I continue to log the issues on my note pad. Sky news is the worst, bbc4 and racing tv not there, along with a lot of other channels showing "not available" .| Fri 11 Dec 2020 9:11:29 #97 | -
I live approximately 15 miles north of the Sandy Heath TV transmitter, just outside Peterborough.
With an outside aerial on the chimeny I have no issues with TV reception from SH and yes, the aerial does point at SH not Waltham or Tacleneston. Two aerials and combiner/amp were needed to get CH5 up until digital switch over. These have were removed ages ago.
Dont still have 2 aerials by any chance?| Fri 11 Dec 2020 9:20:40 #98 | -
Bogbody - hi - no I don't have 2 aerials - was a terminology error - had a splitter.
| Fri 11 Dec 2020 9:48:42 #99 |
Reply »
You must log in to post.