Coz that draws more electricity and I'm a tight arse! 
Plus I'm out of sockets on my 6 gang.
My Humax Forum » Freeview HD » FVP 4000T, 5000T
New software version 1.01.11
(133 posts)-
| Mon 23 May 2016 13:43:20 #91 |
-
Disappointing update for me - none of the epg or recordings screen layouts resolved.
Is a future update going to address these, does anyone know?
| Mon 23 May 2016 13:45:15 #92 | -
Since this update which happened automatically I have been experiencing difficulty in turing the box on and getting a signal through to the tv. this has happened about 4 times. when I turned the box on I sometimes get no signal and have to reboot the humax by turning it off and on again at the wall before it will begin to work. Is there a solution for this.
| Mon 23 May 2016 14:38:40 #1 | -
Just had a polite moan to Humax and they have suggested I try a different HDMI port on the TV. Let's give that a go tonight. #PatienceOfASaint
| Mon 23 May 2016 14:55:55 #93 | -
Allan S - 58 minutes ago »
Since this update which happened automatically I have been experiencing difficulty in turing the box on and getting a signal through to the tv. this has happened about 4 times. when I turned the box on I sometimes get no signal and have to reboot the humax by turning it off and on again at the wall before it will begin to work. Is there a solution for this.Admin Note: Moved you post to thread already open on subject.
Have you tried turning off HDMI-CEC is the System Settings menu.
Failing that try turning off CEC on your TV if there is a setting for it.
| Mon 23 May 2016 15:39:37 #95 | -
Thanks Barry I will try that
| Mon 23 May 2016 16:32:23 #96 | -
Another freeze and mains switch off, restore factory settings and it wont get past the red light! Thats two humax cappuccino I have gone through in a week. Wont turn on, wont work. Absolutely crap software update!
| Mon 23 May 2016 19:49:04 #97 | -
Software update has trashed my machine too. It ran faultlessly since last November, but since the software update it's misbehaving. After 5-10 minutes, the picture stutters and freezes and the remote no longer works at all. A restart fixes it all, but then it fails again after a while.
I've done a factory reset, but the problems persist.
Not very happy...
| Mon 23 May 2016 22:09:47 #98 | -
Re picture stuttering, freezing.
I have been in discussions with Humax Support as I have witnessed the stuttering on live, and any timer recording at the time fails as the unit has to be power cycled.
This issue (amongst others I have spotted) has been reported to Humax Towers engineers for further investigations.
Why oh why Humax did not use the beta group to test this beforehand
| Tue 24 May 2016 9:03:37 #99 | -
Overall I have been lucky and found the update mainly an improvement. But there are still faults prevalent which were identified in the Beta. Netflix and recordings causing speaker clicks. The Netflix app appears to be the the same one as used for the Beta which had minor viual faults highlighted.
Fingers crossed for another update sooner rather than later.| Tue 24 May 2016 12:15:48 #100 |
Reply »
You must log in to post.
