My Humax Forum » Freesat HD » HDR 1000, 1010, 1100S

Installation wizard freeze

(5 posts)
  1. User has not uploaded an avatar

    Ians07

    new member
    Joined: Feb '15
    Posts: 3

    offline

    Have suffered like many with the recent on demand problems with 1000s and was advised to try factory reset. Unfortunately, have on restarting the unit simply freezes in the installation wizard. Other than on demand access, worked fine previously and so satellite and tv connections are all fine. Anyone able to help?

    | Sun 15 Feb 2015 15:09:29 #1 |
  2. REPASSAC

    REPASSAC

    special member
    Joined: Mar '11
    Posts: 4,100

    offline

    Two suggestions:

    1. Disconnect from mains for a few minutes and then re-try.
    2. If no luck in 1. I remember seeing someone's suggestion to disconnect the LNB's and retry. Power off first before disconnecting. I am rather doubtful about this myself.

    I presume you are seeing a TV picture when it freezes?

    | Sun 15 Feb 2015 16:29:38 #2 |
  3. User has not uploaded an avatar

    Ians07

    new member
    Joined: Feb '15
    Posts: 3

    offline

    Have tried with all connections out, but to no avail. TV picture appears on initial start up, but then disappears - only action is "installation wizard" scrolling across the box.

    | Sun 15 Feb 2015 17:19:24 #3 |
  4. REPASSAC

    REPASSAC

    special member
    Joined: Mar '11
    Posts: 4,100

    offline

    Ians07 - 2 hours ago  » 
    Have tried with all connections out, but to no avail. TV picture appears on initial start up, but then disappears - only action is "installation wizard" scrolling across the box.

    I think that perhaps the wizard is not frozen - perhaps the TV has missed a resolution change. Do you have a SCART connector to just try setup again. I have seen other posts with this exact problem.

    | Sun 15 Feb 2015 19:58:11 #4 |
  5. User has not uploaded an avatar

    Ians07

    new member
    Joined: Feb '15
    Posts: 3

    offline

    Connection is via SCART (no HDMI on TV). What action should I take?

    | Sun 15 Feb 2015 20:18:30 #5 |

RSS feed for this topic

Reply

You must log in to post.